Verfasste Forenbeiträge
-
Beiträge
-
Try to measure on the voltage regulator that pages right after the micro usb plug, that it is the one that has gone?
Use less electricity, eg 3v and targets.
You may also want to change the power cable, with micro usb.
salute naxswillYes the tube is built at home based on articles that have been in elector to bake from 1998 onwards. experience elektronics.de
salute naxswill
It is also only blocks 4 that are the problem, the first 3 plex glass blocks are ok, am-pm, etc.
will try to later adjust the collection, so as to see if it helps?
Yours sincerely, RobertThe right link is for elektor home page
see below Home, Garden, Games, Hobby (LED-Nixie-Clock)Sorry Robert
There are 3 pictures posted on the electrical forum as it was easier.
see below Home, Garden, Games, Hobby (LED-Nixie-Clock)
hilsen RobertThanks for the answer.
Yes the foil / plastic has been removed so it is not that side in the way of the light,
The problem is well in the accuracy of the material, because even though it is laser cut, 1/10 mm inaccuracy is very much in the holes that the led should light up through?
It is fascinating that you can cut so thinly via laser technique, but since it is collected by a fine plus 2 boad, inaccuracies may well arise.
Have tried to slow down the display but it has not helped and they are just as difficult to remove again after it is inserted.
Yours, Robert
